Baby Lock embellisher EMB12 Manual de instrucciones descargar pdf (Pagina 12)

1. Rotate the yarn & ribbon guide toward the back

of the machine. Align the guide with the top of

the yarn stand pin.

2. Place ribbon on the yarn stand.

3. Insert the ribbon into the slot of the yarn &

ribbon guide.

4. Rotate the ribbon guide toward the front of the

machine.

5. Insert the ribbon into slot of the ribbon

guide.

6. Rotate the handwheel to bring the needle bar to

its highest position.

7. Slide ribbon into the ribbon slot of the cloth

presser.

8. Raise the cloth presser lifter lever.

9. Place fabric under the cloth presser.

10. Lower the cloth presser lifter lever.

ATTENTION: Only guide the fabric towards the

back of the machine while embellishing with ribbon

or using the ribbon slot on the cloth presser to

avoid the ribbon from getting tangled.

NOTE: Maximum width of the ribbon slot is 10mm

therefore ribbon over 10mm is not recommended

for this machine.

If ribbon is narrower than 10mm the needles will

embellish on out

side of ribbon area.

Since there is such a wide variety of ribbons to

select from use care when using dense or thick

ribbons. It is recommended to test sew a sample

using all ribbons before sewing on your project.

urn handwheel several times to insure there is no

resist

ance with needle penetration.

6. Ribbon Embellishing

1 2 ... 7 8 9 10 11 12 13 14 15 16

Sin comentarios

Baby Lock embellisher EMB12 Manual de instrucciones Pagina 12